Blolite® Blowable Fiber
The Blolite system offers the highest quality of Corning® optical fiber in standard types of multimode 62.5/125, 50/125 (1GB) or 50/125 (10GB), and singlemode 9/125, all with a special blowable coating and available in 12 colors. The fibers are stripped and terminated with standard tools and compatible with standard fiber optic connectors.

Blolite® Blowable Fiber

Blolite® Microduct
Microducts are empty plenum and non-plenum tubes that provide a pathway/conduit for blowing the fiber through the network. Up to twelve fibers can be installed simultaneously into each Microduct using the Blolite installation technique.

Blolite® Non-Plenum 5mm Microduct
Blolite® Plenum 5mm Microduct
Blolite® Non-Plenum 8mm Microduct
Blolite® Plenum 8mm Microduct

Blolite® Multiduct
Multiduct is a jacketed bundle of Microduct tubing available in 2-, 4- or 7-way configurations. Multiduct cable is offered in plenum and non-plenum for indoor and dry duct outdoor installations. Outdoor-rated, high-capacity 19 Way Multiduct is available and can be configured for installations in outside plant ducts and direct burial.

Blolite® Indoor Non-Plenum 5mm Multiduct
Blolite® Indoor Plenum 5mm Multiduct
Blolite® Indoor Non-Plenum 8mm Multiduct
Blolite® Outdoor 5mm Multiduct
Blolite® Outdoor 8mm Multiduct
Blolite® Outdoor 19 Way Multiduct

Blolite® Connectors
Simple push-fit connectors join the Microduct sections and extend the Microduct network to each destination. A transparent center section of the connectors permit visual inspection to verify if the path is empty or populated with optical fiber. Blolite connectors come in straight or tee configurations. Duct connector plugs and end caps provide a method of sealing unused tubes during shipment, storage and installation.

Blolite® Duct Connector (Straight and Tee) and Duct Connector Plugs and End Caps

Blolite Installation Equipment
The Blolite installation equipment kit (rental only) consists of an Air Supply Conditioning Unit (ACU) – complete with filtration and air-drying units, and the Installation Module – a blowing head utilizing a mechanically driven system to feed the fibers into the Microduct. A lightweight Tripod is the third component used to support the Installation Module. This equipment operates on standard compressed air at safe, low pressures.

Blolite® Installation Equipment